Szénerőművek füstgázkéntelenítéséből származó REA-gipsz és víz jellemzőinek, a deponálás környezeti hatásainak meghatározása, a hasznosítás lehetőségei  részletek

súgó  nyomtatás 
vissza »

 

Projekt adatai

 
azonosító
37390
típus K
Vezető kutató Kovács Ferenc
magyar cím Szénerőművek füstgázkéntelenítéséből származó REA-gipsz és víz jellemzőinek, a deponálás környezeti hatásainak meghatározása, a hasznosítás lehetőségei
Angol cím Characteristic of Byproduct Gypsum and Scrubber Water of Lignite-fired Power Plants, Enviromental Effects of their Disposal, Ways of Utilization
zsűri Földtudományok 2
Kutatóhely Bányászat és Energia Intézet (Miskolci Egyetem)
résztvevők Bőhm József
Csoke Barnabás
Kovács Károlyné dr. Németh Lívia
Molnár József
Namesánszki Károly
projekt kezdete 2002-01-01
projekt vége 2005-12-31
aktuális összeg (MFt) 8.212
FTE (kutatóév egyenérték) 0.00
állapot lezárult projekt





 

Zárójelentés

 
kutatási eredmények (magyarul)
Meghatároztuk a REA-gipsz kémiai összetételét, szemnagyság és mechanikai jellemzőit. A tiszta gipsz közepesen-lassan kötő anyag, kötés utáni szilárdsága 12-15 MPa. Erőműi pernyéből és a REA-gipszből kompozit anyagokat állítottunk elő, meghatároztuk azok optimális keverési arányát. A kompozit anyagok szilárdsága megfelelő ahhoz, hogy belőle előre gyártott beltéri gipsz építőelemek készülhessenek. A csapadék és talajvíz között határozott kapcsolat-kommunikáció mutatható ki, a rétegvízszintek alakulása viszont független a csapadék mennyiségétől és a talajvízszint változásától. A füstgázkéntelenítésből szárzamazó REA- gipsz és víz deponálása során nem történik olyan mértékű káros anyag kioldódás, ami kármentesítési intézkedéseket indokolna. A salak-pernye-gipsz depónia felületének kiporzás vizsgálata azt igazolta, hogy a REA-gipsz anyag bekeverése jelentős mértékben, egynegyedére-egyötödére csökkenti a depónia felületének kiporzását.
kutatási eredmények (angolul)
Chemical composition, grain size distribution and mechanical characteristics of the byproduct gypsum was determined as a result of the research. Pure gypsum is proved to be medium and slow setting binding agent of 12-15 MPa compressive strength. Composite materials were produced using fly ash and byproduct gypsum which optimal composition was determined as well. Compressive strength of the composite materials in question enables manufacturing in-door wallboard elements using these industrial wastes. Direct influence of quantity of precipitation was observed only on water table in the soil, but practically there was no fluctuation in the deeper water-bearing layers. Dissolution of components of the gypsum could not be observed as well in the groundwater even quite close to the disposal areas, consequently measure should not be taken to avoid adverse effects. Studying aerial erosion of the surface of the disposed ash and gypsum proved, that only 20-25 % of the earlier quantity of the dust was blown away by the wind if gypsum were mixed in the upper layer of the fly ash. Ways of utilization of the results of the research were studied by the Mátrai Erőmű Zrt. company. Further operation of the waste site was approved by the appropriate authorities.
a zárójelentés teljes szövege http://real.mtak.hu/190/
döntés eredménye
igen





 

Közleményjegyzék

 
Ferenc Kovács – József Molnár – József Valaska: Chemical and mechanical characteristics of biproduct gypsum produced in a hungarian lignite-fired power plant, Mining in the 21st Century Quo Vadis? Volume 2.pp. 1305-13-11. Oxford and IBH Publisting Co.Pvt. Ltd. New Delhi ISBN 81-204-1608-0, 2003
F. Kovács – J. Molnár: Basic properties of flue-gas desulfuriation gypsum, High Technologiesz tendencies of development., 2003
Ferenc Kovács – József Molnár – József Valaska: Chemical and mechanical characteristics of biproduct gypsum produced in a hungarian lignite-fired power plant, Mining and Geotechnology Environmental Management Series A. Mining, Volume 65(2003) pp. 3-10., 2003
József Molnár: Basic Mechanical Properties of Compsites Made of Fly Ash and FGD Gypsum., Geotechnics 2004, Slovakia, ©trbske Pleso, The High Tatras. The Conference Proceedings (ISBN 80-8073-151-9), pp. 543-548., 2004
József Molnár: Composite Construction Materials Made of the Byproducts of Generating Electrical Energy Produced in a Hungarian Coal-Fired Power Plant., Abstract, submitted to the 20th World Mining Congress., 2005
Kovács Ferenc – Molnár József: A Mátrai Erőműben keletkező filterpernyéből és füstgáz kéntelenítési gipszből készített kompozit anyagok szilárdsági tulajdonságainak vizsgálata, Miskolci Egyetem Bányászati és Geotechnikai Tanszék, 2005
Ferenc Kovács: The relationship between open cut dewatering and groundwater level fluctuation, Abstract, 20th Wolrd Mining Congress, 7-11. November 2005. Teherán, Irán, 2005
Ferenc Kovács: The relationship between open cut dewatering and groundwater level fluctuation, International conference on Computer Aided Design and Manufacturing CADAM’05 September 27th – October 1st 2005. Supetar-Croatia, 2005
Ferenc Kovács: A füstgázkéntelenítésből származó REA-gipsz és- víz deponálása során jelentkező környezeti hatások., microCAD 2006. Nemzetközi Tudományos Konferencia 2006. március 16-17. Miskolc, 2006
Szarka Györgyi: Lignittüzelésű erőmű égéstermékeinek kiporzás vizsgálata, microCAD 2006. Nemzetközi Tudományos Konferencia 2006. március 16-17. Miskolc, 2006




vissza »